KNX TH-UP Pure White Combined Indoor Sensor. TEMPERATURE AND AIR HUMIDITY

The KNX Sensor TH-UP Touch measures the concentration, temperature and humidity of the room air and calculates the dew point. The sensor can receive external temperature and humidity measurements via the bus and process them with its own data to obtain overall values (mixed values, e.g. room average).

The KNX TH-UP Touch has two touch buttons that can be used to change the room temperature (setpoint temperature), to switch between operating modes or as freely programmable push buttons.
as freely programmable push buttons.

The KNX TH-UP Touch has configurable thresholds. Threshold outputs and other communication objects can be connected via AND and OR logic gates. In addition, an integrated control variable comparator makes it possible to compare and output values that were received via communication objects.

Integrated PI controllers control a ventilation (depending on air humidity) and a heating/cooling (depending on temperature). The KNX TH-UP Touch can send a warning to the bus as soon as the
the bus as soon as the comfort zone is exceeded (in accordance with DIN 1946).

The integrated display shows the eigenvalues and data transmitted via the bus (e.g. date, time). The device is completed by a frame of the switch panel used in the room and is integrated into the installation.
the room and integrates into the interior installation in a harmonious and uniform manner.

Functions:

• - Temperature and humidity measurement (relative and absolute), dew point calculation.
• - Mixed values obtained from own measured values and external values (share adjustable to percentage)
• - Display 1-3 lines (measured values or values transmitted via the bus) or display for temperature control (see also Mode display and manual temperature controller, page 2).
• - 2 touch buttons. Configuration as push buttons or for changing the setpoint temperature and switching between operating modes (see also Changing the room temperature with push buttons, page 2).
• - PI controller for heating (one or two-stage) and cooling (one or two-stage) depending on temperature. Control according to setpoint values or basic setpoint temperature.
• - PI controller for humidity-dependent ventilation: Airing/ventilation (one-stage) or ventilation (one or two-stage).
• - Adjustable limit values via parameters or via communication objects: 3 × temperature, 2 × humidity
• - 4 AND logic gates and 4 OR logic gates with 4 inputs each. All switching events and the 16 logic inputs can be used as inputs for the logic gates in the form of communication objects. The output of each gate can be
• configured as 1 bit or 2 x 8 bits.
• - 2 control variable comparators for outputting minimum, maximum or average values. 5 inputs respectively for values received via communication objects.