MOTION DETECTOR RECESSED IN CEILING 360º KNX

• KNX PIR motion detectors with luminosity sensor.
• The lux level and time delay can be set with the control knobs, by using the IR remote control (EM MAN DM0) or via ETS.
• One PIR sensor and a high resolution lens can detect the smallest movement.
• Depending on the parameterization by ETS, this detectors can work as:

– Motion detection: depending on the movement and the daylight.
– Twilight switch: teach-in brightness threshold for daylight-dependent switching.
– Constant light control: with dimming telegrams.
– Signal monitoring: motion detection without brightness sensor.
– Brightness sensor: light sensor without motion detection.
– Temperature sensor: sends the temperature value.

• Detection area of 360º and maximum 7m at 2.5m high.
• Flush ceiling mounted.
• Power supplied by the Bus.
• Programation by ETS3 or later version.

 

TECHNICAL CHARACTERISTICS

Product reference	DM KNT 001
Power Supply (V)	21Vcc - 32Vcc
Consumption	9,3mA
Output channels	1
Maximum Number of Equipments	0
Detecting angle (º)	360
Mounting height (m)	2.5
Coverage diameter (m)	7
Programming by	ETS3 or later
Start up	System Mode
Minimum Time setting (seconds)	0,1
Maximum Time setting (minutes)	85
Minimum Brightness level (lux) (min)	5
Maximum Brightness level (lux) (max)	1000
Tecnology	Infrareds (PIR)
Mounting	Flush ceiling
Admits contactor	No
Zero crossing point	No
Compatible with	KNX
Minimum Working Temperature (ºC) (min)	-5
Maximum Working Temperature (ºC) (max)	45
Protection Degree	IP20, Class II